Complete the mechanism for the given decarboxylation by adding any missing atoms, bonds, charges, nonbonding electrons, and curved arrows

Answer:

Newton's first law: the law of inertia

Newton's first law states that if a body is at rest or moving at a constant speed in a straight line, it will remain at rest or keep moving in a straight line at constant speed unless it is acted upon by a force.

Explanation:

Anything aka if a body is at constant speed in a straight line it would probably remain or keep moving in a straight line unless something slows it down like Fricton.

Answer:

answer down below

Explanation:

it has similar mass but the white dwarf is much denser

Answer:

Because Geography says the higher one goes the colder it gets

Answer:

The nature of convection.

Explanation:

Warm air rises; cold air falls, so the freezer at the top provides cold air for the other compartments at the bottom.

Answer:

Johannes Kepler

Answer:

The part of the earth and its atmosphere in which living organisms exist or that is capable of supporting life.

Explanation:

It’s in the definition of biosphere. “Bio” means “life,” so “biosphere” is that portion of the Earth capable of supporting life.

Answer:

d (density) = m / V = (292 - 180) g / 95 cm^3 = 1.18 g / cm^3

(water is 1 gm / cm^3)

Answer:

The Moon orbits Earth once every 27.3 days and spins on its axis once every 27.3 days. This means that although the Moon is rotating, it always keeps one face toward us. Known as “synchronous rotation,” this is why we only ever see the Moon's nearside from Earth.

I hope this helps you out

Answer:

When waves overlap in-phase (crest meets crest or trough meets trough) the waves energy is additive and the amplitude increases.

Explanation:

When waves overlap out-of-phase (crest meets trough) the waves cancel and the amplitude (energy) decreases. When two interfering waves cancel each other out.

The lowest rock layer is a layer that must be rich in organic matter that was subjected to heat and pressure over time during the formation of oil and gas.

The lowest rock layer refers to the lowermost part of the Earth's mantle, which is a thin rock layer (approximately 250 km).

In the Earth, the layers of rocks are progressively deposited, thereby pressing them to the bottom to generate sedimentary rocks.

The lowest rock layers on the bottom must be rich in organic matter to form fossil fuels.

Learn more about rock layers here:

https://brainly.com/question/25846908

Answer:

attached image

Explanation:

The movement of the plates creates three types of tectonic boundaries: convergent, where plates move into one another; divergent, where plates move apart; and transform, where plates move sideways in relation to each other. They move at a rate of one to two inches (three to five centimeters) per year.

Answer:

B. The larger force causes more acceleration than the smaller.

Explanation:

For example, let me use a child and a grown up. The child represents the smaller force while the grown up represents the larger force. If they are pushing the same object of different sides, obviously the side with the grown up will push and move to the side of the child because it is stronger.

Answer:

Electric Charge is the property associated with matter due to which it produces and experiences electric and magnetic effect

Answer:

B

Explanation:

a=v/t

a=(40m/s)÷(80s)

a=0.5m/s

The steps in the separation include;

Separation techniques has to do with how to obtain a substance in the presence of other substances. In this case, we have the substance XYZ mixed with iron filling and sand.

The separation process begins by using a magnet to remove all the iron fillings. Secondly, water is added and the substance XYZ dissolve in water since it is ionic. The sand can be separated form the solution by filtration.

Lastly, the solution is evaporated and the pure XYZ is obtained and sent to the police lab for analysis.

Learn more about separation techniques: https://brainly.com/question/625109

Answer:

Co2

Explanation:

If the current in circuit A is greater than the current in circuit B, then the resistance in circuit A is less than the resistance in circuit B.

Ohms law states that the volatge in a circuit is directly proportional to the current flowing in the circuit.

V = IR

Where;

The given voltage in the circuits

At equal resistance, the current flowing in circuit B will be greater than circuit A since circuit B has more voltage.

However, If the current in circuit A is greater than the current in circuit B, then the resistance in circuit A is less than the resistance in circuit B.

Learn more about ohms law here: https://brainly.com/question/231741

C
- CONNECTIONS
---

much love! <33

Answer:

c. Resin.

Explanation:

Amber is a resin.

What led to Henry Ford’s success as an entrepreneur?

What happens when volcanoes release greenhouse gases into the atmosphere?

Answer:

M = 328.70g

Explanation:

From the given values:

V = 346 cm³

M of 1 cm³ of Polythene = 0.95g or 95/100g

Solve:

M = (95×346)

10

= 32870

100

M = 328.70g

Scientific evidence such as reflection and photoelectric effect has proven the wave-particle model of electromagnetic radiation to be true.

Electromagnetic radiation is radiation produced as a result of the interactions of the electric and magnetic fields.

Some forms of electromagnetic radiation include:

Electromagnetic radiation can be described using a wave model or a particle model.

The wave property of electromagnetic radiation include:

The particle property of electromagnetic radiation include:

Therefore, the wave-particle model of electromagnetic radiation is correct because it can be backed up by experiments and evidence.

Learn more about wave-particle model at: https://brainly.com/question/20452331

Answer:

I just took the identifying Claims Quick check

Explanation:

1. Claim: Electromagnetic radiation can be described by a wave model or a particle model, depending on the situation.

Is this a scientific claim?

Yes, it can be backed up by experiments and evidence.

2. A student states, "The wave model is better than the particle model for electromagnetic radiation because it is easier to understand." Is the student's statement a scientific claim?

No, it isn't because the statement is an opinion.

3. A student wants to make a scientific explanation regarding the wave model of electromagnetic radiation. Which of the following would be part of the scientific explanation?

Claims

4. A student makes this statement before conducting an experiment on electromagnetic radiation: "We expect the laser to diffract when passed through a slit." Which of the following explains why the student's statement is not a claim?

It is a prediction or hypothesis.

5. Which claim do scientists use to describe electromagnetic radiation?

Electromagnetic radiation exhibits properties of both particles and waves.

6. A physician is going to use high-frequency electromagnetic radiation to treat cancer in a patient. Which is a claim about this event?

A wave model is most useful for describing the frequency of the radiation.

Answer: A Nebula is left behind. A spectacular explosion in which a star ejects most of its mass in a violently expanding cloud of debris.

Hope this helps!

Answer:

10 hours.

Every 10 hours, Jupiter will rotate at least once. It takes 12 years for Jupiter to make a revolution. This is because Jupiter is a gas, non-solid planet and also has a very large mass.

Answer: 10 Hours

Explanation:

Jupiter is the fastest spinning planet in the solar system

Answer:

9.8 m/s2

Its value is 9.8 m/s2 on Earth. That is to say, the acceleration of gravity on the surface of the earth at sea level is 9.8 m/s2. When discussing the acceleration of gravity, it was mentioned that the value of g is dependent upon location.

The measured specific heat will be less than the actual specific heat if a lower value is gotten than the actual mass.

This is defined as the quantity of heat needed to raise a substance's temperature by 1 degree Celsius.

If a substance has a low specific heat capacity , it loses water easily which makes the mass when measured to be smaller than the actual value.

Read more about Specific heat capacity here https://brainly.com/question/1401668

Gwen's position is a function of his velocity and time

Gwen's position at 45 seconds is 63.9 feet

The function is given as:

v(t) = 250sin(t^2/120)/(t + 6)

When t = 45, we  have:

v(45) = 250sin(45^2/120)/(45 + 6)

Evaluate the sum, the exponent and the quotient

v(45) = 250sin(16.875)/(51)

Evaluate the sine ratio

v(45) = 250 * 0.2903/51

Evaluate the product and quotient

v(45) = 1.42

The position is then calculated as:

S(45) = v(45) * 45

This gives

S(45) = 1.42 * 45

Evaluate the product

S(45) = 63.9

Hence, Gwen's position at 45 seconds is 63.9 feet

Read more about velocity function at:

https://brainly.com/question/10962624

The displacement is the shortest between any two given points. The displacement of Gwen at the time period of 45 seconds is 63.9 feet.

The displacement is the shortest between any two given points. It is the product of velocity and time.

Given that the function of the velocity is [tex]v(t)=\dfrac{250\sin\left(\frac{t^{2}}{120}\right)}{\left(t+6\right)}[/tex]. Therefore, substitute the value of t as 45, to know the velocity of Gwen at 45 seconds,

[tex]v(t)=\dfrac{250\sin\left(\frac{t^{2}}{120}\right)}{\left(t+6\right)}[/tex]

[tex]v(45)=\dfrac{250\sin\left(\frac{45^{2}}{120}\right)}{\left(45+6\right)}\\\\v(45) = 1.42[/tex]

Since displacement is the product of velocity and time, therefore, the displacement is equal to,

[tex]s = v \times t\\\\s = 1.42 \times 45\\\\s = 63.9\rm \ feet[/tex]

Hence, the displacement of Gwen at the time period of 45 seconds is 63.9 feet.

Learn more about Displacement:

https://brainly.com/question/11934397

#SPJ4

Answer:

400N

Explanation:

Newton's second law of motion

F = ma

20 x 20 = F

F = 400

For E = 200 gpa and i = 65. 0(106) mm4,  the slope of end a of the cantilevered beam  is mathematically given as

A=0.0048rads

Generally, the equation for the   is mathematically given as

[tex]A=\frac{PL^2}{2EI}+\frac{ML}{EI}[/tex]

Therefore

A=\frac{10+10^2+3^2}{2*240*10^9*65*10^6}+\frac{10+10^3*3}{240*10^9*65*10^{-6}}

A=0.00288+0.00192=0.0048rads

A=0.0048rads

In conclusion,  the slope is

A=0.0048rads

Read more about Graph

https://brainly.com/question/14375099

The value of slope of end a of the cantilevered beam when E = 200 gpa and i = 65. 0(106) mm4 is 0.0048 rads.

The formula used to find the slope at the end of the cantilevered beam is,

[tex]A=\dfrac{PL^2}{2EI}+\dfrac{ML}{EI}[/tex]

Here, (M) is the momentum, (EI) is flexural rigidity, (P) is concentrated load and (L) is the length of the beam.

Concentrated load is 10 KN and uniform load is 3 kN/m. E = 200 gpa and i = 65. 0(106) mm4.

[tex]A=\dfrac{10+10^2+3^2}{2\times240\times10^9\times65\times10^6}+\dfrac{10+10^3\times3}{240\times10^9\times65\times10^{-6}}\\A=0.00288+0.00192A=0.0048 \rm\; rads[/tex]

Thus, the value of slope of end a of the cantilevered beam when E = 200 gpa and i = 65. 0(106) mm4 is 0.0048 rads.

Learn more about the cantilevered beam here;

https://brainly.com/question/19090244

#SPJ4