Help,

The question is down below

Answer:

They need to have a full outer shell to be stable so they bond with each other and share electrons to become stable forming a compound.

Explanation:

Hope this helps!

✏28 neutrons are in vanadium.

❤XxMrprathamxX13❤

28 neutrons in Vanadium- round 50.9 to 51 then do 51-23=28

Answer:

Staphylococcal infection can affect the: Skin: Most commonly, Staphylococcus aureus bacteria cause skin infection. This can produce boils, blisters, and redness on the skin.

Explanation:

Answer:

acting ability i think hope it helps

d, long toes because that’s genetic. where as a, b, and c are more social characteristics

I think you forgot to put the image

Answer:1)The reason as to why scientists opt to transmit data at lower frequency  instead of electromagnetic even if it can carry more data at a higher frequencies is because using higher frequencies of electromagnetic spectrum travel shorter distances but have higher data carrying capacity.So this physical characteristic of electromagnetic waves limits the range and availability of frequencies for sending information.

2) Limitations of using electromagnetic waves in sending communication

communication is a process of transmitting and receiving information in the form of signals.high technology communication use electromagnetic waves,there are various types of electromagnetic waves which are used in communication which include radio-waves,microwaves,infrared  e.t.c some of their limitations are

i)Because there is limited number of broadcast frequencies the use of transmitters must be restricted  in some way or they will seriously interfere with each other.

ii)Through the air signals can be distorted by atmospheric conditions and signals from space are sometimes distorted by solar activity

iii)physical activities such as mountains and buildings can prevent or interfere with some transmissions

iv)Through the air signals are not private,so any tuned receiver within the range can pick up them.

3)Differences between digital and analogue signals

Analogue and digital signal are used to transmit information usually through electric signals.

An analogue signal is continuous wave denoted by sine wave and may varry in signal strength (amplitude) or frequency(time) an example is sound from human voice is analogue because waves are continuous..

A digital signal is a signal in which the original information is converted into a string of bits before being transmitted .example a must for computer processing where is described as using (0s and 1s)and therefore can not take any fractional value.

4)Advantages of using digital signals over analogue signals

one advantage of digital signals are inherently less susceptible than analog signals to interference caused by noise because with digital signal it is not necessary to evaluate precise amplitude,frequency or phase.

Another advantage based in capacity is that digital signals carry more information per second than analogue signals.

Digital signals maintain their quality over long distances better than analogue signals.

5)How we use digital and analogue signals in our everyday live

digital signal processing is the way of life of current generation  

example is mobile phones do alot of digital signal processing .they process our our speech digitally to remove background noise,echo  e.t.c

Television also do a lot of digital processing of video,audio signal to present them in a better way.

How radio telescopes are used to explore space

A radio telescope is a specialized antenna and radio receiver used to receive radio waves from astronomical radio sources in the sky in radio astronomy.It has several main parts, a dish and antenna,a receiver,a detector and an analyzer.The dish collects the radio signals from space ad focuses them on the antenna.

6)How radio waves are used on earth

Radio waves are used to transmit television and radio programs They have longer wave lengths and are reflected by the ionosphere

7) Reasons why telescopes convert radio waves (analog) to electrical(digital) signals for analysis

This is because signals can be easily stored and transmitted in digital form.The analog is continuous in time and it is necessary to convert this to a flow of digital values.

Explanation:

couldnt make my own so...

Answer:

Explanation:

READ THIS AND ANSWER THE QUESTIONS BELOW!!!!!!!!!1

Celestial bodies emit different types of radiation, only some of which can be detected by traditional telescopes. Radio waves are invisible rays that can be detected only by radio telescopes. A radio telescope functions like a television antenna. Radio waves from space are sensed by a gigantic parabolic reflector, which concentrates them toward the top of a focusing antenna. A radio receptor converts the radio waves into electrical signals which are amplified and then transmitted to the center of the parabola. They are then recorded and analyzed in the laboratory so that scientists can obtain a radio image of the source observed. The parabolic antenna can usually be oriented to detect radio waves from all directions of space. Some radio telescopes are fixed. The largest radio telescope in the world, located in Arecibo, Puerto Rico, is fixed. Built in a natural valley shaped like a giant parabola, its reflector measures 305 meters in diameter. Mobile detectors suspended from cables permit the scanning of one of part of the sky. Unlike traditional telescopes, radio telescopes can be used both day and night, even when there is cloud cover.

Electromagnetic waves can carry more data at higher frequencies. Why would a scientist opt to transmit data at a lower frequency instead?

What are the limitations of sending information using electromagnetic waves?

What are the differences between analog and digital signals?

What are the advantages of using digital signals over analog signals?

Using reliable internet sources, identify three ways we use analog and digital signals in our everyday lives.

Answer:



Explanation:



Answer:

The rates at which reactants are consumed and products are formed during chemical reactions vary greatly. Five factors typically affecting the rates of chemical reactions will be explored in this section: the chemical nature of the reacting substances, the state of subdivision (one large lump versus many small particles) of the reactants, the temperature of the reactants, the concentration of the reactants, and the presence of a catalyst.

Explanation:

Reactions occur when 2 molecules effectively collide, each having minimum energetic and correct orientation.

The starting material or materials for a chemical reaction are referred to as the reactants. The substance or substances produced from a chemical reaction are called products. Sometimes a secondary product, a byproduct, can also be created at the same time as the desired product(s).
Not every chemical reaction occurs in the same way. There are different types of chemical reactions, including synthesis reactions, decomposition reactions, and displacement reactions. In this experiment, a decomposition reaction takes place. During a decomposition reaction, a compound breaks apart into two or more products. Most decomposition reactions need an outside source of energy in order to take place.
Hydrogen peroxide is not a very stable compound, so it slowly decomposes into water and oxygen gas under normal conditions. In this reaction, yeast is used as a catalyst. A catalyst is a substance that helps to change the rate of a reaction. During the reaction, the catalyst is not consumed. As a result, the yeast makes the reaction occur much faster; it causes the hydrogen peroxide to break down and release the oxygen gas much faster.
The soap is used to help us “see” the reaction. Bubbles of oxygen become trapped in the soap, creating foam. The reaction occurs so quickly, releasing so much gas and creating so much foam, that the foam begins to flow out of the bottle. The result of this reaction looks like toothpaste being squeezed out of a tube.
In addition, the bottle will feel warm to the touch because the reaction is exothermic. An exothermic reaction or process is one that gives off energy. In contrast, an endothermic reaction or process is one that requires or absorbs energy.
HYPOTHESIS
uAdding yeast to hydrogen peroxide
will cause the hydrogen peroxide to
decompose quickly into water and oxygen gas, creating foam as the gas becomes trapped in liquid dish soap and pushes upward out of the bottle.
FORMULAS & EQUATIONS
Hydrogen peroxide is a relatively clear liquid substance. It is soluble in water and is often sold as a mixture of H2O2 in water. The hydrogen peroxide used in this experiment is actually a 6% solution of H2O2 in water.
The chemical formula for hydrogen peroxide is H2O2.
Hydrogen peroxide naturally decomposes into water and oxygen gas. The reaction is shown by the following equation:
2H2O2 (aq)g2H2O (l) + O2 (g)
The rate of the reaction can be increased by introducing a catalyst. In this experiment, the catalyst is yeast. Yeast is a microorganism that is part of the fungi family. Therefore, in the equation below, the catalyst is indicated above the arrow.
yeast
2H2O2 (aq) g 2H2O (l) + O2 (g)
The hydrogen peroxide used in the experiment is
actually a mixture of water and hydrogen peroxide.
CONNECT TO THE YOU BE THE CHEMIST CHALLENGE
For additional background information, please review CEF’s Challenge study materials online at http://www.chemed.org/ybtc/challenge/study.aspx.
• Additional information on elements, compounds, and physical and chemical changes can be found in the Classification of Matter section of CEF’s Passport to Science Exploration: The Core of Chemistry.
• Additional information on chemical reactions can be found in the Chemical Reactions section of CEF’s Passport to Science Exploration: Chemistry

When it mixes the chemicals react to one another and form elephant toothpaste