quicklime which is calcium oxide, is made by heathig limestone in a furnace as per the equation :
CaCO3(s)CaO(s)+CO2
7.00Kg of calcium oxide was formed. what mass of calcium carbonate was heated?

Answer:he is correct

Explanation: when Donald runs all his weight is moving at the same speed so when all that weight hits a stopped object the weight will transfer its force into that object Kinda like how a truck hits a car

Answer:

the angular acceleration of the car is 1.5 rad/s²

Explanation:

Given;

initial angular velocity, [tex]\omega_i[/tex] = 10 rad/s

final angular velocity, [tex]\omega_f[/tex] = 25 rad/s

time of motion, t = 10 s

The angular acceleration of the car is calculated as follows;

[tex]a_r = \frac{\omega_f - \omega_i }{t} \\\\a_r = \frac{25-10}{10} = 1.5 \ rad/s^2[/tex]

Therefore, the angular acceleration of the car is 1.5 rad/s²

hope this helps

Answer:

If a person is pushing a desk across the room, then there is an applied force acting upon the object. The applied force is the force exerted on the desk by the person.

Answer:

A final velocity that is faster than an initial velocity.

Explanation:

The acceleration of an object is given by :

[tex]a=\dfrac{v-u}{t}[/tex]

Where

v is final velocity and u is initial velocity

t is time taken

If the final velocity is more than the initial velocity, the acceleration is positive. So, the correct option is (a).

Answer:

Total cost = #6.2

Explanation:

Given the following data;

Voltage = 240 V

Power = 40 W

Time = 62 hours

Cost = #2.50

To find the cost of running the lamp for 62 hours;

First of all, we would determine the energy consumption of the electric lamp

Energy consumption = power * time

Energy consumption = 40 * 62

Energy consumption = 2480 Watt-hour = 2.48 Kwh (1 Kilowatts is equal to 1000 watts).

Next, we would determine the cost of running the lamp;

Total cost = energy consumption * cost

Total cost = 2.48 * 2.50

Total cost = #6.2

Explanation:

i. Vi=24

Vf=0

t= -2

a=vf-vi/t =0-24/12 = -2m/S2

ii. F=ma = 1500×-2= -3000 N

Answer:

Figure is not there

Explanation:

i think the data is not complete but that's according to me

Answer:

Oh, umm…

Jump! (The higher, the better!)

Drop your pencil! (or pen or ruler, whichever you prefer!)

Throw a ball of paper! (and make sure you pick it back up later!)

Explanation:

if you satisfied to my answer , just put brainliest please , and ur welcomeee♥️♥️

Answer:

The final position is  (2, 7)m

Explanation:

When we work with coordinate pairs, the addition works as:

(a, b) + (c, d) = (a + c, b + d)

So, for example, if we start at (a, b), and we have a displacement d = (1, 1)

we just need to solve:

(a, b) + (1, 1) = (a + 1, b + 1)

Now, in this case, we start at (4, 4)m

first, we have d1 = (2, -3) m

After this displacement, the position is:

(4, 4)m + (2, -3)m = (4 + 2, 4 - 3)m = (6, 1)m

Now we have a displacement d2 = (-5, 0) m

After this, the position is:

(6, 1)m + (-5, 0)m = (6 -5, 1 + 0)m = (1, 1)m

After this, we have the final displacement d3 = (1, 6) m, so the final position will be:

(1, 1)m + (1, 6)m = (1 + 1, 1 + 6)m = (2, 7)m

Below you can see a rough sketch of the path that the student take, where he/she starts at point A.

Answer:

I don't understand the Question

Answer:

The heat produced in the longer wire is 200 J.

Explanation:

When the two wires are connected in parallel then the voltage across both the wires is same.

Let the length of the second wire is L and the radius of the second wire is R.

The length of the first ire is 2L and the radius of the first wire is 2R.

Heat produced in the second wire is 100 J.

Let the heat produced in the first wire is H'.

The resistance of the wire is proportional to length of the wire and inversely proportional to the area of the wire.

[tex]\frac{R_2}{R_1}=\frac{L\times \pi\times 4R^2}{2L\times \pi\times R^2}\\\\\frac{R_2}{R_1}=2[/tex]

The heat produced is given by

[tex]H=\frac{V^2}{R}\\\\\frac{H_1}{H_2}=\frac{R_2}{R_1}\\\\\frac{H_1}{100}=2\\\\H_1=200 J[/tex]

Explanation:

Glass is the best sound absorber material.

Answer:

Energy Transfer Quiz - Quiz

The diagram shows a heater above a thermometer. The thermometer bulb is in the position shown.

Answer:

The iron bolt is attracted to the electromagnet. The force of attraction between the electromagnet's core and the iron bolt is greater than the force of the spring, so the iron bolt is pulled out of its housing in the door

Explanation:

answer = 33.4 net force.

Complete question is;

A sudden loud sound such as an explosion can damage the ear, as can long-term exposure to high levels of sound.

A) True

B) False

Answer:

True

Explanation:

This sudden sound described in the question is usually referred to as an impulse sound which can cause damage to hearing. Furthermore, it can lead to a type of hearing loss where one experiences buzzing, roaring or ringing sounds in one's ears.

Thus the statement in the question is true.

Explanation:

u=40

v=?

h=?

v²-u²=2gs

0²-40²=2×10×s

160=20s

s=160/20

=80m/s

total distance= upward distance ×downward distance

=80+80

=160m

total displacement=0 because u and v is the same.

Answer:

The maximum height is 80 m and the total distance covered by the stone is 160 m and the displacement is zero.

Explanation:

Final velocity v = 0

Initial velocity u = 40m/s

We know that,

Using equation of motion

[tex]v^{2} =u^{2} +2gh[/tex]

[tex]0-40^{2} =2[/tex] × [tex]10[/tex] × [tex]h[/tex]

The maximum height is:

[tex]h=80[/tex] [tex]m[/tex]

The  stone will reach at the top and will come down

Therefore, the total distance will be:

[tex]s=h_{1} +h_{2}[/tex]

[tex]s=80m-80m=160m[/tex]

The net displacement is:

[tex]D=h_{1} -h_{2}[/tex]

[tex]D=80m-80m=0[/tex]

Hence, The maximum height is 80 m and the total distance covered by the stone is 160 m and the displacement is zero.

hope this helps.....

Answer:

V²=U² + 2as

Where V=Final Velocity

U=Initial Velocity

a=acceleration ( Deceleration in this case)

s=distance covered

10² = 30² + 2(a)(20)

100 = 900 + 40a

100 - 900 = 40a

-800=40a

a= -800/40

a= -20ms-².

Its negative because the car Decelerated.

Answer:

The density of brass is approximately 8,261.73 kg/m³

Explanation:

The percentage composition by mass of brass is given as follows;

The percentage by mass of copper = 67%

The percentage by mass of zinc = 33%

The density of copper, ρ₁ = 8.96 g/cm³

The density of zinc, ρ₂ = 7.133 g/cm³

Therefore, where we have, m = 100 g of brass, we have;

The mass of copper, m₁ = 67 g

The volume of copper, V₁ = m₁/ρ₁

∴ V₁ = 67 g/(8.96 g/cm³) ≈ 7.47767857 cm³

The volume of zinc, V₂ = m₂/ρ₂

∴ V₂ = 33 g/(7.133 g/cm³) ≈ 4.62638411 cm³

The volume of the brass, V = V₁ + V₂

V = 7.47767857 cm³ + 4.62638411 cm³ ≈ 12.104 cm³

The density of brass, ρ = m/V

∴ ρ = 100 g/(12.104 cm³) ≈ 8.26 g/cm³

The density of brass, ρ ≈ 8.26 g/cm³ = 8,261.73 kg/m³

Answer:

The mass of the dog food added is 9.03 kg

Explanation:

Given;

mass of the shopping cart, m₁ = 14.5 kg

let the mass of the bag added = m₂

the force applied, F = 12 N

initial velocity of the cart-bag system, u = 0

distance traveled by the system, d = 2.29 m

time of motion of the system, t = 3.0 s

The acceleration of the system is calculated as;

[tex]d = ut + \frac{1}{2} at^2\\\\2.29 = 0 + (\frac{1}{2} \times 3^2)a\\\\2.29 = 4.5 a\\\\a = \frac{2.29}{4.5} \\\\a = 0.51 \ m/s^2[/tex]

The total mass of the system (M) is calculated as follows;

F = Ma

M = F/a

M = (12)/(0.51)

M = 23.53 kg

The mass of the dog food added is calculated as;

m₂ = M - m₁

m₂ = 23.53 kg - 14.5 kg

m₂ = 9.03 kg

Answer:

Explanation:

The definition of acceleration is the change in velocity over a period of time. If the girl's velocity is constant, that means it's not changing. Therefore, acceleration is 0 m/s/s

Answer:Whenever the velocity of the object increases or usually doubles, the kinetic energy will be quadrupled. If in case you are not familiar with kinetic energy, this is known as the type of energy that is in motion. The greater the mass of the object, the greater the total of the energy

Explanation:

Change to an object would quadruple its kinetic energy Increasing its velocity to twice its original value

In physics, the kinetic energy of an object is the energy that it possesses due to its motion. It is defined as the work needed to accelerate a body of a given mass from rest to its stated velocity. Having gained this energy during its acceleration, the body maintains this kinetic energy unless its speed changes. The same amount of work is done by the body when decelerating from its current speed to a state of rest. Formally, kinetic energy is any term in a system's Lagrangian which includes a derivative concerning time.

In classical mechanics, the kinetic energy of a non-rotating object of mass m traveling at a speed v is [tex]{\textstyle {\frac {1}{2}}mv^{2}}[/tex]

In relativistic mechanics, this is a good approximation only when v is much less than the speed of light.

The standard unit of kinetic energy is the joule, while the English unit of kinetic energy is the foot-pound.

Learn more about kinetic energy

https://brainly.com/question/12337396

#SPJ2

Answer:

fhddjdhdjndvdbhd honcho highchair suck Vicki

Answer:

So, option(a).

Explanation:

Momentum is the measure of motion of the object.

Momentum is given by the product of mass and the velocity of the object.

(a) It is false.

(b) It is true, momentum is transferred.

(c) It is true, As the momentum of the system is conserved when no external force is applied on the system.

(d) It is true, as the momentum is associated with the velocity of the object.

Answer:

1= Kidneys

2= Ureters

3=Bladders

4=Urethra

Explanation:

Functions of kidney: Regulations of water balances, excretions of nitrogenous wastes(urea)

Functions of Liver: Detoxifications, protein synthesis

Functions of Skin: Temperature regulations, Metabolic functions, Excretion

Functions of lungs: Respiration, Water balance regulations

Tip: If you want faster and correct answers you should label your questions under the correct subject.

Answer:

c. potential energy only

Explanation:

at highest point the body will having some height and gravitational force will work on it.

since the velocity at highest point will be zero therefore there will no kinetic energy