Sometimes people state that speed and velocity are the same. People make such a mistake because they forget that velocity describes both speed and——————

Answer:

prefix that means 1/100 = Centi

prefix that means 1,000 = Kilo

prefix that means 1/1000 = Milli

Explanation:

Answer:

if there is only one planet in the universe and the ball is there it will have 0 kinetic energy if the ball is in the very center of that planet only if the planet itself is absolutely motionless. its at its highest if the planet is moving away from the ball at a slightly faster speed forever. Between point A and B both potential energy and kinetic energy are at perfect 0.

Explanation:

never will have a measurable kinetic or potential energy status unless every single object is included in the calculation.

Answer:

Infinite

Explanation:

Young's modulus is infinite and bulk modulus is zero.

Answer:

Young's modulus is the ratio of tensile stress ( force of elasticity ) to tensile strain ( extension ).

Explanation:

[tex]E = \frac{stress}{strain} [/tex]

Answer:

2. Letter C all those in the list are non living

3. Letter A a skunk is a living organism that shapes its environment

5. Letter A when talking about population it usually refers to a single type of species in that area

6. Letter B Niche (just recently heard of the word in ecology)

Answer:

The ratio of forces is 22 : 3.

Explanation:

Case I:

initial velocity, u = 35 mph

final velocity, v = 0

time, t = 15 ms

Case II:

initial velocity, u = 35 mph

final velocity, v = 0

time, t' = 110 ms

let the mass is m.

According to the Newton's second law, the force is given by the rate of change of momentum.

So

[tex]F =\frac{m(v-u)}{t}\\\\F'= \frac{m(v-u)}{t'}\\\\So, \frac{F}{F'} =\frac{t'}{t}\\\\\frac{F}{F'}=\frac{110}{15}=22:3[/tex]

Answer:

Given,

w= 180J

s=60m

W=F×s

180=F×60

180/60=F

F= 3 N

Answer:

Explanation:

I'm assuming you missed the decimal point in the initial velocity and that it should be 4.0 m/s. If after a half of a second it is moving a tiny bit slower, it would be because of air resistance. You can only neglect air resistance if the problems you are doing tell you neglect it.

Answer:

Air resistance

Explanation:

I got it correct on the quiz :)

Answer:60

Explanation:

Answer:

The refractive index of the outer coating is 1.52.

Explanation:

Refractive index of interior part, n' = 1.97

critical angle, C = 50.4°

Let the refractive index of the coating is n.

Use the Snell's law,  

[tex]n\times sin r = n'\times sinC\\\\n\times sin 90 = 1.97 \times sin 50.4\\\\n = 1.52[/tex]

Answer:

105.6 KJ

Answer

3.7/5

4

hope this will help you friend.

Answer:O que faz o longa se destacar é seu cenário mergulhado na cultura chinesa e a delicadeza com que o luto e sua superação são tratados.

Explanation:

Por que se você pensar ela estava sempre buscando superar a morte da mãe.

Answer:

556

Explanation:

Answer:

the ballon is purple

Explanation:

x for a smaller magnet at the position marked zin

What is the activity of a source that emits 1,200 particles per minute?

[tex]\boxed{ B. \:20 \:Bq }[/tex]

Explanation:

20 Bq is the activity of a source that emits 1,200 particles per minute. Activity is the number of decays per second. The SI unit for activity is becquerel (Bq).

[tex]\bold{ \green{ \star{ \orange{Mystique35}}}}⋆[/tex]

Answer:

B) 20 Bq

The activity of a source that emits 1,200 particles per minute is 20 Bq.

-------------------------

☆hope it helps

☆have a great day!!

Answer:

hlw its jess bregoli

your answer is here

SI (International System of Units) (meter-kilogram-second-ampere-kelvin-mole-candela)

FPS (foot-pound-second)

MKS (meter-kilogram-second)

CGS (centimeter-gram-second)

EMU (Electromagnetic) (centimeter-gram-second-abampere)

ESU (Electrostatic) (centimeter-gram-second-abcoulomb)

Atomic (bohr-electron mass-atomic second-electron)

MTS (meter-tonne-second)

Explanation:

hope it may help you !!

Answer:

there are 4 types of systems. They are ,

SI - accepted world wide

MKS - meter  kilogram  second

CGS - centimeter  gram  second

FPS - foot  pound  second

hope it helps.

Answer:

sorry I can help im not doing this as yet

Answer:

20 = 30 / t1

t1 = 3/2

40 = 30 / t2

t2 = 3/4

average speed = total distance / total time taken

= 30 + 30 / 3/2 + 3/4

= 60 /9/4

= 60 × 4/9

= 26.667

Answer:

A. Mg+2

Explanation:

im not sure, but since it lost two electrons which have a negative charge it gained two charge.

Answer:

1. Efficiency

2. Kinetic energy

3. Pulley

4. Screw

5. Wedge

Explanation:

1. Efficiency: the ratio of work output to work input or the ratio of actual mechanical advantage (AMA) to ideal mechanical advantage (IMA).

Mathematically, the efficiency of a machine is given by the formula;

[tex] Efficiency = \frac {MA}{IMA} * 100 [/tex]

2. Kinetic energy: the energy of a moving object. Kinetic energy (KE) is an energy possessed by an object or body due to its motion.

Mathematically, kinetic energy is given by the formula;

[tex] K.E = \frac{1}{2}MV^{2}[/tex]

Where;

K.E represents kinetic energy measured in Joules.

M represents mass measured in kilograms.

V represents velocity measured in metres per seconds square.

3. Pulley: a grooved wheel over which a rope can move. It is made up of a wheel and rope which allows force to be multiplied such as in a drawing well.

4. Screw: a double-sided inclined plane. It is held in position and then used to tighten two or more objects together.

5. Wedge: an inclined plane wrapped around a cylinder. It can be used to split objects into halves.

Answer:

there it is fella tried on ma own observation

Answer:

Linear motion, also called rectilinear motion, is one-dimensional motion along a straight line, and can therefore be described mathematically using only one spatial dimension.

Explanation:

Rotation around a fixed axis is a special case of rotational motion. The fixed-axis hypothesis excludes the possibility of an axis changing its orientation and cannot describe such phenomena as wobbling or precession

Answer:

Explanation:

There are a couple of things we need to clear up before we start the problem. First of all, we are given an angle in the problem along with an initial velocity. BUT this is what I call a "blanket" velocity: it is neither the upwards velocity nor is it the horizontal velocity. In order to find either the upwards velocity or the horizontal velocity we have to use either the sin or the cos function, respectively. Since we are working ONLY in the y-dimension, which is up and down, we use the sin function along with the given velocity to find the upwards velocity of the ball. Secondly, we have to know that the final velocity at the max height of the ball is 0. So here is what we have:

v₀ = 12sin14 so

v₀ = 2.9 m/s

a = -9.8 m/s/s

v = 0 m/s

Δx = ??? m

The equation we need is

v² = v₀² + 2aΔx and filling in:

0 = (2.9)² + 2(-9.8)Δx and

0 = 8.4 - 2.0 × 10¹Δx and

-8.4 = -2.0 × 10¹Δx so, to the correct number of sig dig,

Δx = 170 m

Answer:

300cm^3

Explanation:

1ml = 1cm^3

=>300 ml = 300 cm^3

Explanation:

First find the area of the entire floor:

Area of a rectangle= length × width

( 4000mm× 3600mm)

14400000mm²

Area of one square tile??= side ×side

12cm×12cm

144cm²

Convert cm to mm

1cm²=100mm²

144cm²=144cm²/1cm²×100mm²

=14,400mm²

Number of tiles required to cover the entire floor= 14400000mm²/14400mm²

=1000

Given, mass of the man, m=60kg

Kinetic energy of the man, E

k

=750J

If v is the velocity of the man, then

E

k

=

2

1

mv

2

or v=

m

2E

k

=

60

2×750

=5m/s

Answer:

[tex]{ \bf{kinetic \: energy = \frac{1}{2}m {v}^{2} }} \\ { \tt{ 750= \frac{1}{2} \times 60 \times {v}^{2} }} \\ { \tt{ {v}^{2} = 25 }} \\ \\ { \tt{v = \sqrt{25} }} \\ { \bf{velocity = 5 \: m {s}^{ - 1} }}[/tex]